Air Cleaner, Muffler - EMAK K 700 H Workshop Manual

Workshop manual

5.2.3. Air cleaner, Muffler

a Disassembly / Reassembly
Warning
Loosen the drain bolt and
drain the carburetor before
disassembling. Fuel vapor
or spilled fuel may ignite.
Throttle reset spring
Governor lever
High tension
cord
Insulator gasket
Choke lever
Disassembly: Pull the carburetor forward to a point
where the groove in the throttle arm lines up with the
governor rod, and lift the rod out of the hole on the
throttle arm. Unhook the anti-surge spring from the
throttle lever. Remove the carburetor from the
cylinder head.
Reassemble in the order contrary to the order of
disassembly.
Fuel tube
Carburetor gasket
Carburetor insulator
Reassembly: Blow out the passage using
compressed air and install, noting the
installation directions on inner and outer
sides. After installing, securely install high
tension cord and fuel tube.
High
tension
cord
Governor rod
Groove
Throttle
33
Fuel tube
Choke lever
Reassembly: Plug the fuel tube with the
choke lever's lug after removing the fuel
tube to prevent fuel leakage.
Throttle return
spring
Fuel tube
Choke
lever