Operation; Put On Mask; Remove Mask; Dismantle/Assemble Mask - Weinmann Homecare NP15 Instructions For Use Manual

water condenses in the mask tube. Follow
the instructions for use of the respiratory
air humidifier.

4 Operation

All the figures are on the enclosed leaflet.

4.1 Put on mask

1. Select a suitable nasal pillow.
2. Push nasal pillow onto mask body
(Fig. B).
3. Push nasal pillow against nostrils.
4. Pull headgear over head (Fig. K).
5. Using the Velcro tab on crossband 2 on
the head, adjust the width of the head-
gear so that the crossband is located
centrally on the head (Figs. H-J).
6. Adjust forehead strap 15 and cheek
strap 16 using the Velcro tabs on both
sides so that the mask seals on the
face, but is not too tight.
7. Keep the tabs of forehead support 4
depressed.
8. Engage the forehead support in one of
the seven positions (numbers 1-7,
Fig. C) so that the mask seals on the
face but is not too tight.
9. Connect mask tube 10 to the ventila-
tion tube of the therapy device via tube
adapter 7.
Tip
• The ball joint allows you to guide the
mask tube freely (Fig. I). You can attach
it to the headgear on the side (Fig. J) or
top (Fig. H) using the tube anchoring
strap.
• If you wish to fix the mask tube to the
head for sleeping, first connect the
mask tube to the ventilation tube of the
therapy device. You can then either
attach the mask tube to the forehead
support using tube anchoring clip 3
and/or to the top of the headgear using
tube anchoring strap 9.
• Ensure that there is a secure, airtight
connection to the ventilation tube. The
connection may not come loose as a
result of therapy.

4.2 Remove mask

1. Remove mask without changing
settings.
2. Disconnect mask tube from the
ventilation tube of the therapy device.

4.3 Dismantle/assemble mask

1. Take plug off pressure measurement
port (Fig. F).
2. Release mask tube and rotating
sleeve 11 from elbow.
3. Release nasal pillow from mask body.
4. Release forehead cushion from fore-
head support by pulling sideways
(Fig. D).
17
EN