Setting Charging Characteristics - LEAB ABC SCHUTZKLASSE II User Manual

7 Setting charging characteristics

7 Setting charging characteristics
To set a charging characteristic, proceed as follows:
1. Turn the potentiometer to the desired position (see characteristics sheet in
Appendix).
NOTE! The arrow in the middle of the potentiometer indicates the selected
characteristic.
2. To prevent accidental adjustment of the charging characteristic, stick the
supplied sticker on the potentiometer. NOTE! Ensure that the notch in the
sticker is above the LED.
ð The charging characteristic is set.
Adjusting the output voltage
You can adjust the output voltage with the potentiometer (±0.75 V).
To change the output voltage, proceed as follows:
1. Turn the potentiometer for fine adjustment until the desired charge voltage
is reached.
ð The output voltage is adjusted.
12 LEAB Automotive GmbH
Notice
Battery defect due to incorrect charging
To protect the battery from damage due to incorrect charging, set
a suitable charging characteristic before installation. Follow the
battery manufacturer's instructions.
Notice
Battery defect due to incorrect charge voltage
If you use the fine adjustment, check the charge voltage regularly.
LEAB Automotive GmbH
Thorshammer 6 24866 Busdorf