Emerson Rosemount 5408 Reference Manual page 128

Service and troubleshooting
March 2023
7.4.10 View input registers
Measured data is continuously stored in the input registers. By viewing the contents of the
input registers, expert users can check that the transmitter works properly.
Procedure
1. Select Configure → (Manual Setup) → Level Setup → Advanced → Expert Options →
2. Type the desired register number to start reading from.
3. Select Read Input Registers (Refresh in Rosemount Radar Master Plus).
4. (Handheld communicator) Select Input Registers.
7.4.11 View holding registers
The holding registers store various transmitter parameters, such as configuration data,
used to control the measurement performance.
Procedure
1. Select Configure → (Manual Setup) → Level Setup → Advanced → Expert Options →
2. Type the desired register number to start reading from.
3. Select Read Holding Registers (Refresh in Rosemount Radar Master Plus).
4. (Handheld communicator) Select Holding Registers.
7.4.12 Edit holding registers
Edit holding registers using Rosemount Radar Master Plus
Prerequisites
Note
Do not use holding registers to configure the transmitter unless you are qualified. This
dialog is mainly used for service purposes and for advanced configuration.
Procedure
1. To change a holding register value, type a new value in the corresponding value
2. Select Save to store the new value.
Edit holding registers in DD compliant host
Prerequisites
Note
Do not use holding registers to configure the transmitter unless you are qualified. This
dialog is mainly used for service purposes and for advanced configuration.
128
Input Registers.
In Rosemount Radar Master Plus, registers can also be viewed by selecting a group
from the Block list.
Holding Registers.
In Rosemount Radar Master Plus, registers can also be viewed by selecting a group
from the Block list.
field, or select a new value from the corresponding list.
Reference Manual
00809-0100-4408
Reference Manual