Table of Contents
Advertisement
Post-Build Maintenance
Cleaning the Printer Using the Cleaning Wizard
Cleaning the Print Sled Surfaces
1. Remove the four protection strips.
2. After removing the protection strips, clean the print sled surface of all powder.
Figure 44: Cleaning the protection strips
Fused powder
Used (white) and fused (yellow) powder collects on the areas around all three lamps during the
printing process. The powder that collects around the fusion lamp (lamp #3) is often hardened
and difficult to remove due to the higher duty cycle. In this case use, a spatula to remove the
fused powder from the sled surface.
Page 199
© Copyright 2022 Stratasys. All rights reserved.
Advertisement
Table of Contents
