Table of Contents
Advertisement
Post-Build Maintenance
Cleaning the Distribution Sled Protection Strips
1. Remove the distribution sled protection strips for lamps #1 and #2.
2. If the protection strips are covered with fused powder, use a spatula to scrape away the
fused material.
3. If the sled protection strip cannot be properly cleaned, it must be replaced.
Remember to perform this cleaning procedure away from the printer top plate
surfaces. Failing to do this may result in melted hard powder entering the powder
system from the dosing blade area or the overflow area.
Figure 34: Sled protection strip before cleaning
Figure 35: Sled protection strip after cleaning
Figure 36: Sled protection strip requiring replacement
© Copyright 2022 Stratasys. All rights reserved.
Cleaning the Printer Using the Cleaning Wizard
If the fused powder
can be removed the
strip can be reused
Page 191
Advertisement
Table of Contents
