Table of Contents
Advertisement
Loading Material
Refilling Powder
The H350 printer is equipped with a powder container that can hold 50 kg (110 lbs.) of powder,
which is the equivalent to the amount typically needed for two full builds. There is a mixing
wheel inside the powder container that mixes the powder after the container is filled and keeps
the power mixed during the build.
In order to operate the printer, the amount of powder in the container must be enough to
complete the selected build.
The software monitors the level of the powder in the container. This value is displayed at the
bottom left corner of the main screen in the GUI. Each line corresponds to a 20% of the total
volume. In the example shown below, the powder level is in the range of 60%-80%.
Caution: Damage to Printer
The H350 printer is material specific, and is set up to use either High Yield PA11 or
SAF™ PA12. Do not load the wrong material as it will cause damage to the printer.
Material type and level
© Copyright 2022 Stratasys. All rights reserved.
Figure 13: Powder level
Material type and level
Refilling Powder
Page 112
Advertisement
Table of Contents
