Table of Contents
Advertisement
Post-Build Maintenance
4.
Figure 37
powder (black area) and the fused powder (yellow area) need to be scrapped carefully with
a spatula after the strip is removed from the sled.
shows an example of sled protection strip that requires cleaning. The burned
Figure 37: Dirty sled protection strip
Areas requiring
scraping with a
spatula
It is recommended to replace the dirty sled protection strips with clean ones during
weekly maintenance. The removed, dirty sled protection strips can then be cleaned
while the printer is operating.
© Copyright 2022 Stratasys. All rights reserved.
Cleaning the Printer Using the Cleaning Wizard
Page 192
Advertisement
Table of Contents
