Heartland Ovation 2800 Owner's Manual page 31

Pausing a Session
To pause the session, press the Start/Stop button. The flashing period on
the lower right corner of the display will stop flashing and stay illuminated.
To restart, press the Start/Stop button on the Heartland Timer. The period
on the lower right corner of the display will resume flashing.
NOTE: The session time will continue to count down. The display will
continue to update and reflect the remaining session time.
Canceling a Session
To cancel a session, press the Start/Stop button to pause the session, then
press the Up button. The display will show a solitary 0.
REMOTE SINGLE BED CONTROL
4
Remote Single Bed Control is the ability to control a single tanning bed
from a remote location. T-Max 3A at the remote location is required for
this configuration.
Wiring
Wire the Heartland Timer to the tanning bed. Apply power to the T-Max 3A
as described in their respective User's Guides. Run the provided modular
cable from the tanning room to the remote T-Max 3A. Connect the
modular cable to one of the RJ-22 ports on the Heartland Timer and
T-Max 3A (see RJ-22 ports for T-Max Series timers on page 29, figure B).
Configuration
Set the address on the Heartland Timer in the tanning room to 1. Set the
address on the T-Max 3A to 0.0. For setting the delay, refer to the T-Max 3A
User's Guide.
NOTE: When setting the address on the Heartland Timer in the tanning
room, the power to the front desk or T-Max 3A must be off.
SESSION CONTROLS
Starting a Session
1. Press the Up or Down button on the T-Max 3A or the Set button on the
T-Max 1A at the front desk until the session time is displayed. Time
cannot be set from the Heartland Timer in the room.
www.heartlandtan.com 31 10/27