STEP 8.
Install RJ-22 cable from your communication network (see timer
section for details).
STEP 9.
Connect the jumper cord located on the back of the canopy,
to the terminal on the back of the bench. (Fig. F)
STEP 8.
Assemble the facade using six (6)10-24 hex nuts as shown below
(Fig. G)
STEP 10. Attach facade to legs using magnets on the back of the
facade.
STEP 11. Wire bed accordingly.
NOTE: ELECTRICAL CONNECTION TO POWER SUPPLY MUST BE IN
COMPLIANCE WITH NECA REGULATIONS AND MUST BE PERFORMED BY A
QUALIFIED ELECTRICIAN.
IF YOU HAVE ANY QUESTIONS, PLEASE CALL
www.heartlandtan.com
Fig. F
Fig. G
1-800-554-8268
41
10/27