Heartland Ovation 2800 Owner's Manual page 25

REPLACING HIGH-PRESSURE FACIAL LAMPS
3400
1. Disconnect power from unit.
2. Remove two (2) quarter-turn fasteners at the front edge of the
acrylic using a #2 Phillips screwdriver.
3. Pull the front edge of the acrylic rail down from the canopy
allowing the acrylic to hinge down from the back of the canopy.
4. Remove acrylic from the hinge rail exposing the facial assembly.
5. While holding the facial glass door, remove two (2) retaining screws
using a #2 Phillips screwdriver.
6. Hinge facial glass door from facial housing exposing the 400W facial
lamps.
7. Grasp the facial lamp from one end pressing towards the opposite
end to release the facial lamp from the lamp holder.
8. Replace the 400W facial lamp.
NOTE: ONLY GRASP 400 WATT FACIAL LAMPS FROM EITHER END;
ALWAYS USE ALCOHOL TOWEL PROVIDED WITH LAMP TO WIPE
OFF LAMP AFTER INSTALLATION.
9. Reverse the procedures above to reassemble.
CAUTION: DO NOT CHECK FACIAL LAMP OPERATION
WITH FACIAL GLASS CASSETTE REMOVED.
ALWAYS WEAR UV PROTECTIVE EYEWEAR WHEN REPLACING LAMPS AND
CHECKING OPERATION.
www.heartlandtan.com 25 10/27