Heartland Ovation 2800 Owner's Manual page 27

OVERVIEW
Congratulations on your purchase of Applied Digital, Inc.'s T-Max Series of
tanning bed timers. The T-Max Series is designed for complete automation and
control of your tanning equipment. A Heartland Timer is an OEM board that can
be installed in a tanning bed or tanning booth. Each Heartland Timer can
individually control a tanning bed, can be connected back-to-back with a T-
Max 3A for remote front desk control or be connected with many Heartland
Timers and a T-Max Manager or Manager/Plus/Pro to control many beds from a
remote location. Operation is accomplished via front panel controls. This manual
should be used by the licensed electrician installing your T-Max timing system.
Check for compliance with local building codes.
CONFIGURATION
Setting Parameters
NOTE:
If you are using a T-Max Manager or T-Max Manager/Plus/Pro and multiple
Heartland Timers, remove power from the T-Max Manager or T-Max Manager/
Plus/Pro and keep the power removed until all parameter changes are
complete.
1. Press and hold the Start/Stop and Up buttons simultaneously on the
Heartland Timer until a .1 appears on the display. Release the buttons. This
should take about 5-6 seconds. This is an indication that you are in the
parameter mode. The numbers currently displayed represents the parameter
number that you can observe or change.
2. Press the Up or Down button until the parameter number that you want to
observe or change is displayed.
3. Press the Start/Stop button. The current value for that parameter will be
displayed and flashing. The Heartland Timer will show a number with a period
illuminated in the lower center of the display. The number shown is the
current value for that parameter. For Lamp, Session Counts, etc. the value
displayed can be as high as 9999. To display this value, the Heartland Timer
will flash two numbers-three times, then two numbers-three times, pause, two
numbers-three times, two numbers-three times, pause, etc. For example, 53
three times, then 14 three times, pauses then repeats, then the total lamp
hours stored in that Heartland Timer is 5314.
4. Press the Up or Down button to change the parameter to the desired value.
If you want to clear the value for that parameter, press the Up and Down
buttons at the same time until the display shows 0.0.
www.heartlandtan.com 27 10/27