Heartland Ovation 2800 Owner's Manual page 28

5. Press the Start/Stop button. The display will show the parameter number you
just changed and a solid period in the lower center of the display. You may
now change another parameter by pressing the Up or Down button until the
parameter that you want to change is displayed. Repeat Steps 2-4 for each
parameter you want to change.
6. To exit the Parameter mode and make the Heartland Timer available for the
next session, press and hold both the Up and Down buttons until the display
shows a 0 with no periods displayed.
Setting the address
NOTE: If you are using the Heartland Timer as an independent timer, you don't
need to set the address on the Heartland Timer.
1. Press and hold the Start/Stop and Up buttons simultaneously on the
Heartland Timer until a .1 appears on the display. Release the buttons. This should
take about 5-6 seconds.
2. Press and release the Start/Stop button. A number will appear on the display
and be flashing. A period will be illuminated in the center of the display. Pressing
and holding the Up button will cause the display to count up. Once the count
reaches 100, the center period will flash rapidly. This is an indication that you are
over 99. For example, if the display shows a 0.2 with the period flashing, this is
address 102. The highest the display will count up to is 254.
3. Press the Up or Down button until the desired address is displayed. When
setting the address, remember 3 rules:
A) Set each Heartland Timer to a unique address.
B) Do not set any address to 0.
C) Do not set any address over 100.
4. Press the Start/Stop button. The .1 will appear on the display. The 1 will not be
flashing.
5. To exit, press and hold both Up and Down buttons until the display shows a 0
with no periods displayed.
www.heartlandtan.com 28 10/27