Heartland Ovation 2800 Owner's Manual page 30

Setting Delay Time
If the Heartland Timer is being controlled by a T-Max 3A, T-Max Manager
or T-Max Manager/Plus/Pro, the delay does not need to be set on the
Heartland Timer. The delay is controlled by the controlling device.
1. Press and hold the Start/Stop and Up buttons simultaneously on the
Heartland Timer until a ".1" appears on the display. Release the buttons.
This should take about 5-6 seconds.
2. Press the Up or Down button until a ".3" is displayed.
3. Press and release the Start/Stop button. A number will appear on the
display and be flashing. A period will be illuminated in the center of the
display. This is the current delay time.
4. Press the Up or Down button until the desired delay time is displayed.
The highest delay time that can be set on the Heartland Timer is 10
minutes. If you want no delay time, set the display to 0. If you set the
delay time to 0, the session time will start immediately after the
Start/Stop button is pressed.
5. Press the Start/Stop button. The ".3" will appear on the display. The 3 will
not be flashing.
6. To exit, press and hold both the Up and Down buttons until the display
shows a "0" with no periods displayed.
IN-ROOM SINGLE BED CONTROL
Starting A Session
1. Press the Up or Down button on the Heartland Timer until the desired
session time is displayed. If the display shows a 0, and you want to
count down from the maximum time, press the down button.
2. Press and release the Start/Stop button to start the session. If a delay
other than 0 is entered, the delay will count down. A period on the
lower right corner of the display will flash rapidly. When the session
starts, the period will flash at a once per second rate. If the delay is set
to 0, the session will start immediately.
www.heartlandtan.com 30 10/27