Table of Contents
Advertisement
Figure 116. Installing the 2.5-inch rear drive cage
Next steps
1. Connect all the cables to the rear drive cage.
2.
Install the
drives.
3. If removed,
install the air
4. Follow the procedure listed in
Optional serial COM port
This is a service technician replaceable part only.
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1.
Lift the expansion card riser
system board.
2. Open the latch, slide the serial COM port out of the expansion card riser, and the lock the latch .
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
150
Installing and removing system components
shroud.
After working inside your
Safety
instructions.
Before working inside your system
(Riser 1, Riser 2a, Riser 2c) and disconnect the serial COM port cable from the connector on the
system.
.
Advertisement
Table of Contents
