Table of Contents
Advertisement
Figure 165. Installing the right control panel
Next steps
1.
Install the air
shroud.
2.
Install the backplane
cover.
3.
Install the front
bezel.
4. Follow the procedure listed in
Removing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If applicable,
remove the backplane
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE:
Observe the routing of the cable as you remove it from the system.
2. Open the cable retention latch.
3. Remove the cable from cable clip.
4. Using the Phillips 1 screwdriver, remove the screws that secure the left control panel assembly to the system.
5. Hold the left control panel assembly and remove the control panel along with the cable from the system.
After working inside your
Safety
instructions.
Before working inside your system
cover.
system.
.
Installing and removing system components
195
Advertisement
Table of Contents
