Installing The M.2 Ssd Module - Dell PowerEdge HS5610 Installation And Service Manual

Figure 133. Removing the M.2 SSD module
Next steps
1. If applicable, Install the M.2 BOSS card into the M.2 BOSS
2. If applicable, Install the M.2 BOSS

Installing the M.2 SSD module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Removing the M.2 BOSS
4. Remove the M.2 BOSS card from the M.2 BOSS
Steps
1. Align the M.2 SSD module at angle with the connector on the M.2 BOSS card.
2. Insert the M.2 SSD module until it is firmly seated in M.2 BOSS card connector.
3. Using the Phillips 1 screwdriver, secure the M.2 SSD module on the M.2 BOSS card with the screw.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
162 Installing and removing system components
riser.
Safety instructions.
Before working inside your system
riser.
riser.
riser.
.