Specifying An End Receiver - Aficio 1015 Operating Instructions Manual

Transmission Options
C
Press 0 0 0 0 or 1 1 1 1 until "10. Transfer
Report" is displayed.
1
D
Press the { { { { OK} } } } key.
E
Press 0 0 0 0 or 1 1 1 1 to select "On" or
"Off".
F
Press the { { { { OK} } } } key.
G
Specify the Transfer Station.
If you make a mistake, press the
{Clear/Stop} key and try again.
H
Press the { { { { OK} } } } key.
I
Specify the End Receiver.
Note
❒ You cannot enter the numbers
of the End Receivers directly.
The numbers must be stored in
Quick Dials, Speed Dials or
Groups in the Transfer Sta-
tion(s).
J
Press the { { { { OK} } } } key.
K
Press 0 0 0 0 or 1 1 1 1 to select "Yes" or
"No".
14
L
Press the { { { { OK} } } } key.
If you selected "Yes", go back to
step I.
M
Press the { { { { Start} } } } key.

Specifying an End Receiver

When you make a Transfer Request,
you must specify the final destina-
tions (End Receivers) for your mes-
sage.
You cannot enter the numbers of the
End Receivers directly. Instead, enter
a simple code that describes where
the numbers are stored in the Trans-
fer Station (in Quick Dials, Speed Di-
als or Groups).
The numbers must first have been
stored in Quick Dials, Speed Dials or
Groups in the Transfer Station(s).
❖ ❖ ❖ ❖ Quick Dial
E nte r {q } follo w ed by t he
number (2 digits) of the Quick Dial
where the End Receiver is stored.
For example, to choose the number
stored in Quick Dial 01 in the
Transfer Station, enter: {q} {0}
{1}
❖ ❖ ❖ ❖ Speed Dial
Enter {q}, {p} followed by the
Speed Dial code (2 digits).
For example, to choose the number
stored in Speed Dial 12 in the
Transfer Station, enter: {q} {p}
{1} {2}
❖ ❖ ❖ ❖ Group Dial
Enter {q} , {p}, {p} followed
by the Group number (2 digits).
For example, to choose the number
stored in Group 04 in the Transfer
Station, enter: {q} {p} {p} {0}
{4}