Solving Problems - Aficio 1015 Operating Instructions Manual

Troubleshooting

Solving Problems

This table lists some common problems and their solutions.
Problem
Image background appears
dirty when a fax is received at
the other end.
Printed or sent image contains
spots.
4
Received image is too light.
Message appears blank at the
other end.
You want to cancel a Memory
Transmission.
You want to cancel an Imme-
diate Transmission.
You cannot add any destina-
tion in Group though it does
not reach the maximum
number.
62
Solution
Adjust the scan density.
The Document Feeder or ex-
posure glass is dirty. Clean
them. See Chapter 5 "Main-
taining Your Machine"in the
Copy Reference.
Make sure that ink or eraser is
dry before setting the original.
Request the sender to increase
the image density.
When using moist, rough or
processed paper, the printed
image may be partly invisible.
Only use recommended paper.
When D appears on the dis-
play, toner is beginning to run
out. Replace the toner car-
tridge soon. See Chapter 3
"Changing the Toner Car-
tridge"in the Copy Reference.
The original was set upside
down. Set it properly.
If the original is being stored,
press the {Clear/Stop} key.
If the original is being sent,
use "Cancel TX/RX" in the In-
formation menu.
Press the {Clear/Stop} key.
99 destinations have been pro-
grammed with the number
keys. Program more numbers
with Quick Dials or Speed Dials.
Refer to
P.29 "Image Density (Contrast)"
---
---
Appendix, "Acceptable Types
of Originals" in the Advanced
Features manual.
---
P.14 "Setting Originals"
P.22 "Canceling a Memory
Transmission"
Chapter 2 "Canceling Trans-
mission or Reception" in the
Advanced Features manual.
P.6 "Operation Panel".
Chapter 3 "Chain Dial"or "Re-
dial" in the Advanced Fea-
tures manual.