Functional Check Procedure; Figure 1-3: Select File Dialog Box - Tektronix RTX130A User Manual

Functional Check Procedure

RTX130A QAM & VSB RF Signal Generator User Manual
4. Cushion the instrument on all sides by tightly packing dunnage or urethane
foam between the carton and the instrument, allowing for three inches
(7.62 cm) of padding on each side (including top and bottom).
5. Seal the carton with shipping tape or with an industrial stapler.
6. Mark the address of the Tektronix Service Center and your return address on
the carton in one or more prominent locations.
Perform the following procedure if you are operating the instrument for the first
time (to verify that the instrument shipped without damage) or you suspect that the
instrument is not working properly:
Before you perform this procedure, install the RTX130A using the
NOTE.
instructions listed in Installation starting on page Up Windows XP Professional.
1. Connect the RTX130A to a power source, and then turn the instrument on
using the ON/STBY switch.
2. Press the front-panel MENU button to display the File menu command list.
3. Press the up ( ) or down ( ) arrow button to select Open from the list, and
then press the ENTER button to open the Select File dialog box shown in
Figure 1-3.

Figure 1-3: Select File dialog box

Getting Started
1-9