Page 1
Instruction Manual TSG-271 PAL Television Generator 070-6304-02 Please check for change information at the rear of this manual.
Page 2
Copyright Tektronix, Inc., 1989, All rights reserved. Printed in U.S.A. Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supersedes that in all previously published ma- terial. Specifications and price change privileges reserved. The following are registered trademarks: TEKTRONIX and TEK.
Page 3
Tektronix, with shipping charges prepaid. Tektronix shall pay for the return of the product to the Customer if the shipment is to a location within the country in which the Tektronix service center is located. Customer shall be responsible for paying all shipping charges, duties, taxes, and any other charges for products returned to any other locations.
For product support outside of North America, contact your local Tektronix distributor or sales office. Service Contact your local Tektronix distributor or sales office. Or visit Support our web site for a listing of worldwide service locations. http://www.tektronix.com For other...
Page 7
Table 3-13 Certifications and Compliances 3-15...
Do Not Operate in Wet/Damp Conditions. Do Not Operate in an Explosive Atmosphere. Keep Product Surfaces Clean and Dry. Provide Proper Ventilation. Refer to the manual’s installation instructions for details on installing the product so it has proper ventilation. TSG-271...
Use Care When Servicing With Power On. Dangerous voltages or currents may exist in this product. Disconnect power, remove battery (if applicable), and disconnect test leads before removing protective panels, soldering, or replacing components. To avoid electric shock, do not touch exposed connections. TSG-271...
Page 43
Table 3–13: Certifications and compliances Category Standards or description EC Declaration of Conformity – Meets intent of Directive 89/336/EEC for Electromagnetic Compatibility. Compliance was demonstrated to the following specifications as listed in the Official Journal of the European Union: EN 50081-1 Emissions: EN 55022 Class B Radiated and Conducted Emissions EN 50082-1 Immunity:...
TSG 271 SPECIFICATIONS Table 3–13: Certifications and compliances (cont.) Category Standards or description Installation (Overvoltage) Terminals on this product may have different installation (overvoltage) category designations. The Category installation categories are: CAT III Distribution-level mains (usually permanently connected). Equipment at this level is typically in a fixed industrial location.
Replaceable Electrical Parts This section contains a list of the components that are replaceable for the TSG-271. Use this list to identify and order replacement parts. There is a separate Replaceable Electrical Parts list for each instrument. Parts Ordering Information Replacement parts are available from or through your local Tektronix, Inc., Field...
Chassis-mounted parts and cable assemblies have no assembly number prefix and are located at the end of the electrical parts list. Tektronix Part No. Indicates part number to be used when ordering replacement part from (Column 2) Tektronix.
05276 ITT POMONA ELECTRONICS DIV 1500 E 9TH ST POMONA CA 91766–3835 PO BOX 2767 05292 ITT COMPONENTS DIV CLIFTON NJ 05828 GENERAL INSTRUMENT CORP 600 W JOHN ST HICKSVILLE NY 11802 GOVERNMENT SYSTEMS DIV 7–3 TSG-271 REV MAY 1994...
Page 98
(UICC) PO BOX 399 5Y400 TRIAX METAL PRODUCTS INC 1800 NW 216TH AVE HILLSBORO OR 97124–6629 DIV OF BEAVERTON PARTS MFG CO 50139 ALLEN–BRADLEY CO 1414 ALLEN BRADLEY DR EL PASO TX 79936 ELECTRONIC COMPONENTS 7–4 REV MAY 1994 TSG-271...
Page 99
ST CHARLES ROAD ELGIN IL 60120 SHAKEPROOF DIV 79963 ZIERICK MFG CO RADIO CIRCLE MT KISCO NY 10549 80009 TEKTRONIX INC 14150 SW KARL BRAUN DR BEAVERTON OR 97077–0001 PO BOX 500 81073 GRAYHILL INC 561 HILLGROVE AVE LA GRANGE IL 60525–5914...
Example: ID CONTROL, (ID CONTROL), or /ID CONTROL. Abbreviations are based on ANSI Y1.1–1972. Other ANSI standards that are used in the preparation of diagrams by Tektronix, Inc. are: Y14.15, 1966 -- Drafting Practices. Y14.2, 1973 -- Line Conventions and Lettering.
Page 146
The Replaceable Electrical Parts List is arranged by assembly number in numerical sequence; the components are listed by component number. Example: Component Number Chassis–mounted components have no Assembly No. prefix. A23 A2 R1234 See end of Replaceable Electrical Parts List Subassembly Assembly Schematic Circuit...
Replaceable Mechanical Parts This section contains a list of the components that are replaceable for the TSG-271. Use this list to identify and order replacement parts. There is a separate Replaceable Mechanical Parts list for each instrument. Parts Ordering Information Replacement parts are available from or through your local Tektronix, Inc., Field...
Page 190
Figure & Index No. Items in this section are referenced by figure and index numbers to the illustra- (Column 1) tions. Tektronix Part No. Indicates part number to be used when ordering replacement part from (Column 2) Tektronix. Serial No.
Page 191
ELGIN IL 60120 SHAKEPROOF DIV 79136 WALDES KOHINOOR INC 47–16 AUSTEL PLACE LONG ISLAND CITY NY 11101–4402 80009 TEKTRONIX INC 14150 SW KARL BRAUN DR BEAVERTON OR 97077–0001 PO BOX 500 82389 SWITCHCRAFT INC 5555 N ELSTRON AVE CHICAGO IL 60630–1314...
Need help?
Do you have a question about the TSG-271 and is the answer not in the manual?
Questions and answers