Description Of The Adaptor Plug; Digital Almemo ® D6 Sensor; Operation As Sensor On Almemo ® Measuring Devices - Ahlborn ALMEMO ZAD 900-AB Series Instruction Manual

4 Product

4.4 Description of the adaptor plug

The adaptor plug featuring the article number ZE 2000-PA is optionally available.
The adaptor plug is intended to serve as a safe assistive device to measure
voltage, current, and power at circuits that are electrically connected directly to the
low-voltage grid (CAT II).
For safety reasons, the jumper can only be connected to the black socket (COM)
and the blue socket (A). The jumper can only be used when no current
measurement is required and the circuit shall merely be closed.
jumper
4.5 Digital ALMEMO
In addition to the I
That way, as a sensor with "DIGI" range they can be plugged on every ALMEMO
measuring device. In doing so, new functions and ranges that are not supported by
the ALMEMO devices themselves can be configured and used with the
®
ALMEMO Control software via a sensor menu stored on the sensor. Regarding
®
the measured values, all functions concerning calibration, correction, and multi-
point adjustment are available as before.
4.6 Operation as sensor on ALMEMO
Via the measuring range "DIGI", the ALMEMO
measured values - from 1 to 4 measuring channels - to the ALMEMO
device, where the measured values are processed as usual. Any channel can be
switched off respectively deactivated and can then be activated again. Certain
function channels can also be programmed and used. The sensor is supplied with
power via the measuring device. To operate a sensor in sleep mode for some
sensors it is necessary to extend the programmed sleep period.
- 10 –
®
D6 sensor
2 C port, the ALMEMO ® D6 sensors feature a second serial port.
®
D6 sensor supplies digital
®
socket
mains plug
measuring devices
measuring
®
®