Part 2 - Configuring Gaia Settings On The New Security Group - Quantum CHECK POINT MAESTRO ORCHESTRATOR 1U Getting Started Manual

More information
See:
"Port Mapping for the Quantum Maestro Orchestrator MHO-140" on page 20
n
"MHO-140 ports on the front panel and their default names in Gaia" on page 76
n
8. From the right pane
Group's Interfaces
9. At the bottom of this page, click Apply.
10. Wait for the Orchestrator to create the new Security Group.
This process takes approximately 10 minutes, and it automatically reboots the assigned Security
Appliances.
11. Connect a cable between the assigned Management port (eth<X>-Mgmt<Y>) on the Orchestrator
front panel and your switch.
More information
See:
"Port Mapping for the Quantum Maestro Orchestrator MHO-140" on page 20
n
"Connecting to the Management Ports with DAC or Fiber Cables" on page 59
n

Part 2 - Configuring Gaia Settings on the New Security Group

1. Connect with a web browser to Gaia Portal on the Security Group (through the assigned Management
port eth<X>-Mgmt<Y>).
https://<IPv4 Address of Security Group>
Example:
https://192.168.10.66
2. Log in.
3. Configure the applicable interfaces and other settings.
More information
See the Gaia Administration Guide for your version:
R81.20 Gaia Administration Guide
n
R81.10 Gaia Administration Guide
n
R81 Gaia Administration Guide
n
R80.30SP Quantum Maestro Gaia Administration Guide
n
R80.20SP Quantum Maestro Gaia Administration Guide
n
Getting Started with MHO-140 - Single Site with Two Orchestrators
Unassigned Interfaces, drag and drop the required Uplink ports to the Security
section.
Quantum Maestro Getting Started Guide | 16