Quantum CHECK POINT MAESTRO ORCHESTRATOR 1U Getting Started Manual page 14

6. Configure the IPv4 settings on the MGMT port on the Orchestrator #1 as required in your network.
Procedure
a. Configure the required IPv4 address and Mask Length:
set interface Mgmt1 ipv4-address <IPv4 Address> mask-length
<Length>
Example:
set interface Mgmt1 ipv4-address 192.168.10.22 mask-length 24
b. Change the state of the MGMT port to "on":
set interface Mgmt1 state on
c. Configure the required Default Gateway:
set static-route default nexthop gateway address <IPv4
Address> on
Example:
set static-route default nexthop gateway address 192.168.10.1
on
d. Save the configuration:
save config
7. Connect the MGMT port of the Orchestrator #1 to your network.
8. Make sure the connection from a computer on your network to Orchestrator #1 works.
More information
With a web browser, connect to this URL:
https://<IPv4 Address you configured on the MGMT port>
Example:
https://192.168.10.22
Notes:
There is no Gaia First Time Configuration Wizard on
n
Orchestrators.
You do not need to install a license on Orchestrators.
n
9. Repeat Steps 1 - 8 for the Orchestrator #2.
You must configure a different IPv4 address than that of the Orchestrator #1.
Getting Started with MHO-140 - Single Site with Two Orchestrators
Quantum Maestro Getting Started Guide | 14