Part 3 - Configuration Of Security Groups; Part 1 - Creating A New Security Group - Quantum CHECK POINT MAESTRO ORCHESTRATOR 1U Getting Started Manual

Part 3 - Configuration of Security Groups

Follow the Getting Started Guide section in the Maestro Administration Guide for your version:
R81.20 Quantum Maestro Administration Guide
n
R81.10 Quantum Maestro Administration Guide
n
R81 Quantum Maestro Administration Guide
n
R80.30SP Quantum Maestro Administration Guide
n
R80.20SP Quantum Maestro Administration Guide
n
THIS INFORMATION WILL BE ADDED TO THE MAESTRO ADMIN GUIDE FOR EACH VERSION

Part 1 - Creating a New Security Group

1. Connect with a web browser to Gaia Portal on the "first" Orchestrator.
https://<IPv4 Address you configured on the Orchestrator MGMT port>
Example:
https://192.168.10.22
2. Log in.
3. From the left navigation panel, click Orchestrator.
More information
The Topology
Pane
Unassigned
Gateways
Topology
Unassigned
Interfaces
4. In the middle pane Topology, at the top, right-click
5. In the Security Group <X> configuration
Time Wizard, and click OK.
6. From the left pane
Security Group's
7. From the right pane
Mgmt<Y>) to the Security Group's
Getting Started with MHO-140 - Single Site with Two Orchestrators
section contains the table that shows these sections (from left to right):
Description
All detected Security Appliances that are not part of configured Security
Groups.
Configured Security Groups with their assigned Security Appliances
and ports.
All interfaces on Orchestrators that are not part of configured Security
Groups.
Unassigned Gateways, drag and drop at least one Security Appliance to the
Gateways section.
Unassigned Interfaces, drag and drop at least one Management port (eth<X>-
Interfaces
Security Groups
window, enter the required information, including the
section.
Quantum Maestro Getting Started Guide | 15
and click New Security Group.
First