Configuring The Tc2201 Bridge Software - Quantum Scalar 50 Upgrade Instructions

Figure 11 Scalar SCSI
Connections (Half-Height
Drives)
Configuring the
TC2201 Bridge
0
Software
Quantum Scalar 50 TC2201 iSCSI Bridge Upgrade Instructions
Tape drive 3
Tape drive 4
After the TC2201 is installed, you must configure the bridge and map the tape
drives and library robotics controller to the iSCSI port. Configuring the
TC2201 consists of the following steps:
• Accessing the TC2201 Bridge
• Discovering Attached Devices
• Configuring the iSCSI Ports
Accessing the TC2201 Bridge
To access the TC2201 bridge:
1 Turn on the library power by pressing the power button located on the
front of the library (see
2 Open a web browser on a PC located on the same subnet as the library.
3 In the field, type http://IPaddress/ where IP address is the IP
Address
address for the Scalar 50 library (refer to the Quantum Scalar 50 User's
Guide PN 81-81768 for information on the Scalar 50 remote management
web pages).
4 Select the
iSCSI Bridge
management web pages.
5 Select the TC2201 bridge you want to configure.
The
TC2201 Home Page
TC2201 Upgrade Procedure
figure 2).
tab from the page on the Scalar 50 remote
Setup
screen displays (see figure
81-81792-01 A01
July 2007
TC2201
Tape drive 1
Tape drive 2
0
12).
11