Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Pressing the POWER switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1.
Turn on the peripheral devices and the display unit.
2.
Remove the front bezel (Option).
3.
Press the POWER switch at the front of the server.
The POWER LED is turned on green and after a while, the logo appears on the display.
Express5800/R120e-2E (16x 2.5-inch Drive Model)
Tips
Wait for at least 40 seconds before turning on the server after connecting the power
cord. (Do not power on the server before amber POWER LED is unlit.)
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
Express5800/R120e-2E User's Guide
1. Turning on the Server
POWER switch
147
Advertisement
Table of Contents
