Panasonic KX-TD500 User Manual page 182

Station Features and Operation (PT/SLT)
• Confirmation tone
Confirmation tone 2 (two beeps) is sent when the previously programmed data is same as
the new data. If it is not, confirmation tone 1 (one beep) is sent. Please refer to Section
"6.1.3 Tone List" for further information on tones.
• You can call the original extension from the Call Forwarding destination extension.
•
Both the Call Forwarding and Do Not Disturb (DND) features can be programmed at the
same time, but either one of them can be activated at a time. You can enable or disable Call
Forwarding or Do Not Disturb (DND) feature by pressing the FWD/DND button while on-
hook. In this case, pressing the button changes the setting as follows:
DND
The lighting patterns of the FWD/DND button are as follows:
• Station or User Programming mode
This feature functions even if the extension is in Station or User Programming mode.
• Remote FWD (Call Forwarding) Cancel — Once
The Manager and the Operators can reach an extension that has set Call Forwarding.
• FWD/DND button
Regarding the PT without the FWD/DND button, it can be assigned to a flexible (CO, DSS,
PF) button by Station, User or System Programming.
• Distinctive Dial Tone
When this feature is assigned to the extension, the extension user may hear a distinctive dial
tone (dial tone 2) after going off-hook depending on System Programming <Section 2.8
System Option, "15. Special dial tone after setting feature" in the Programming Guide>.
[No Answer], [Busy/No Answer]
• The number of rings before the call is forwarded is programmable <Section 2.5 System
Timer / Section 4.3 Extension Line, "Call Forwarding – No Answer Time" in the
Programming Guide>. If "0" is specified in Section 4.3 Extension Line, "Call Forwarding-
No Answer Time" setting in Section 2.5 System Timer works.
[Follow Me]
• This feature can be canceled either at your extension or from the destination extension.
• Class of Service
Class of Service programming determines the extension that can perform this feature
<Section 2.4 Class of Service (COS), "Call Forwarding Follow me" in the Programming
Guide>.
182
FWD OFF
Off: Both features are not set.
Red on : DND mode
Red flash : FWD mode
This setting can be changed by System Programming
User Manual