Panasonic KX-TD500 User Manual page 73

Phantom Button (Assignment)
Allows you to assign a Flexible (CO) button as a Phantom button.
— Be sure that you are in the Station Programming mode: Press [PROGRAM] [9] [9].
PT
(CO)
Press the desired Flexible
(CO) button you wish to
assign as a Phantom button.
<PT Display Example>
Phantom:
CLR
<PT Display Example>
Phantom:xxxx
CLR
To erase an incorrect entry, press the CLR (S2) button or the
TRANSFER (CLEAR) button.
(The TRANSFER button becomes the CLEAR button in the Station
Programming mode.)
— To exit the Station Programming mode: Press [PROGRAM].
Conditions
• The phantom extension numbers must be assigned by System Programming <Section 5.3
Phantom Extension in the Programming Guide> before assigning the Phantom button.
• If you assign the Phantom button to one of the CO buttons (CO 13 through CO 24) on a PT
with 24 CO buttons, such as KX-T7230, and change the telephone to a PT with 12 CO
buttons, such as KX- T7235, you must re-program the setting because CO 13 through CO
24 are not provided with the PT with 12 CO buttons. If you do not change the setting, the
phantom extension call appears on the INTERCOM (ICM type PT) or PDN (DN type PT)
button.
• More than one identical Phantom button cannot be assigned on a single extension.
User Manual
7 2
phantom extension no.
Dial 72. Enter the phantom extension
number (3 or 4 digits).
(-xxxx:Phantom extension number)
Station Programming
AUTO DIAL
STORE
Press STORE.
The STORE indicator lights.
The display shows the initial
programming mode.
73