HARVEST H1362 Assembly Manual page 8

Step 9
st
On the upper flange of the 1 tube bolt cable mount brackets (30420) to the left & right side as shown in
fig.9.1. These will be fastened using (2) 5/8" x 1-1/2" flange bolts & nuts. Be sure to angle the cable mount
bracket slightly upwards as shown in figure 9.1. Assemble (2) 3/4" eyebolts onto brackets using (2) 3/4" flat
washer & (2) 3/4" flange nuts.
Fig. 9.1
Step 10
nd rd
Next the cable truss uprights and cross brackets will be assembled on the 2 & 3 tubes. Start by placing the 2
upright truss brackets (10468D) on the tube and fastening with a total of (12) 3/8" x 1-1/2" flange bolts & nuts.
Leave these a little loose for ease of assembling the cross member. Assemble the cross member (10469A) using
a total of (6) 3/8" x 1-1/2" flange bolts & nuts as shown. After all carriage bolts are tigtenen, place the 1/2"
cable clamps on the out side of the trusses as shown. Thread nuts on by hand but do not tighten.
Fig. 10.1
Fig. 10.2
Harvest International H13XX Assembly Manual Page 8 of 35