FujiFilm FDR D-EVO II Operation Manual page 60

2.5 Wireless Specifications
2
2-14
II
FDR D-EVO Operation Manual
IEEE802.11n (protocol) , 2.4GHz, W52, W53, W56, W58 (frequency)
less (general X-ray room)
(The electric shield does not exist excluding the installation stand or
bed.)
RFID etc.) near this equipment.
We recommend not to use any other wireless devices such as cellular/smart
phones, portable phones, microwave ovens, WAPs, etc. within 2m (6.6 ft) of
the wireless FDR D-EVO
When other wireless devices are used within 2m (6.6 ft), wireless data
communication may be delayed.
(Data will not be lost; if a timeout occurs a retry can be performed after the
cause of interference has been removed)
Do not cover the Flat Panel Sensor (DR-ID 1201SE/DR-ID 1202SE/DR-ID
1211SE/DR-ID 1212SE) with a shield such as a metallic plate as this will
interfere with a wireless communication.
Image Data of the Flat Panel Sensor
interface of Access point
(This value is FUJIFILM measuring result of wireless module, and
actual data rate may vary.)
DR-ID 1211SE/DR-ID 1212SE) will be utilizing the IEEE 802.11n.
The Wireless Access Point (WAP) has a feature that limits the
maximum number of the Flat Panel Sensor per access point to
ensure data integrity. Further the WAP has MAC Address Filtering
(unique IP address) and Wireless LAN Segmentation to ensure
handshaking with only the registered wireless FDR D-EVO
Panel Sensors (DR-ID 1201SE/DR-ID 1202SE/DR-ID 1211SE/
DR-ID 1212SE).
communication between DR-ID 1201SE/DR-ID 1202SE/DR-ID
1211SE/DR-ID 1212SE (Flat Panel Sensor) and access point is
secured by WPA2-PSK encryption with AES (Advanced Encryption
Standard). Data security feature will be enabled during installation
is transmitted between DR-ID 1201SE/DR-ID 1202SE/DR-ID
1211SE/DR-ID 1212SE (Flat Panel Sensor) and access point.,
between access point and the console.
ID 1211SE/DR-ID 1212SE (Flat Panel Sensor) will be paired during
the wireless transmission condition in the primary area, so the FDR
II
D-EVO
897N120339A
II
system.
II
system (DR-ID 1201SE/DR-ID 1202SE/
system can be used stable.
II
Flat