Temperature Sensor; Ventilator - SHERCO 125 Workshop Manual

ELECTRICAL
❱❘ Temperature sensor
Drain the coolant.
•
Remove the temperature
•
sensor from the cylinder
head.
Immerse the sensor [1] in a
•
container filled with coolant
[2] making sure to leave the
terminals out of the liquid.
Immerse a thermometer [3]
•
in the liquid so as to check its
temperature.
Heat the liquid slowly and
•
check the resistance of the
sensor using a multimeter
connected as shown in the
diagram according to the
temperature of the liquid by
referring to the attached
table.
❱❘ Ventilator
Disconnect the fan from the
•
harness.
Connect a 12V battery
•
directly to the fan as shown
in the diagram.
Check that the fan rotates
•
correctly without stiffness or
abnormal noise.
52
ST SERIES