Fork Disassembly And Steering Head Bearings Change - SHERCO 125 Workshop Manual

CHASSIS

1.3 Fork disassembly and steering head bearings change

•
Undo the two M8 screws
the caliper
•
Check brake pads minimum thickness.
Wear limit : 1mm
•
Undo four M8 screws of the handlebar
clamps and remove handlebar.
•
Undo the steering column nut
the triple tree clamp M8 screws
remove it
•
Undo the steering stem counternut,
•
Replace both top and bottom bearings : the ones in the steering head and the steering stem
ones (part number C009 ) , applying grease on it.
•
During reassembly, tighten steering stem counternut so the front end can swing freely , without play and
without hard point. Then place upper fork clamp and tighten its nut.
Tightening torques :
Steering stem counternut : 20 Nm.
Triple clamp screws : 15 Nm
Caliper screw: 24 Nm
8
1
and remove
2
,
then
3
and
4
and its dust cover, then remove the fork from the frame.
4
ST SERIES
2
1 3
5
5
by new
2 1