Rear End; Wheel Bearings Change - SHERCO 125 Workshop Manual

❱❘ Rear end

2.1 Wheel bearings change

•
Hold wheel spindle on the left side and undo
the nut on the right side.
•
Remove the spindle from the left.
•
Remove the wheel and the wheel spacers.
Rear wheel spindle tightening torque :
100 Nm
•
Using a heat gun, heat the hub at the bearing
seat.
•
Extract bearings using a suitable tool ( ø 20 )
•
Replace bearings by new ones
•
Using a vernier caliper, check intern spacer's length and replace it if needed.
12
.
CAUTION
Minimum length :
ST SERIES
118.5mm