Synchronizing The Ecu / With The Butterfly Openning Sensor (Tps) - SHERCO 2012 SE 250i-R Shop Manual

The diagnostic operations are carried out in the menu Function, Test / Active test The diagnostic operations are carried out in the menu Function,
various components of the injection system. When you test a component, a green light will various components of the injection system. When you test a component, a green light will various components of the injection system. When you test a component, a green light will
appear.
You can test the following components: fuel injector, fuel pump, ignition coil voltage and the You can test the following components: fuel injector, fuel pump, ignition coil voltage and the You can test the following components: fuel injector, fuel pump, ignition coil voltage and the
various engine sensors (the bike should be at its operating temperature and running for these various engine sensors (the bike should be at its operating temperature and running for these various engine sensors (the bike should be at its operating temperature and running for these
tests).

Synchronizing the ECU / with the butterfly openning sensor (TPS)

Synchronizing the ECU / with the butterfly openning sens
A feature of the Magneti Marelli system is the requirement to synchronize the injector body with A feature of the Magneti Marelli system is the requirement to synchronize the injector body with A feature of the Magneti Marelli system is the requirement to synchronize the injector body with
the ECU if any of these parts have been replaced. If you have to replace either the fuel injector the ECU if any of these parts have been replaced. If you have to replace either the fuel injector the ECU if any of these parts have been replaced. If you have to replace either the fuel injector
body or the TPS, or both of these electronic components, you must do the following: body or the TPS, or both of these electronic
► Go to the Configuration Menu Go to the Configuration Menu
► Click Erase errors. The green light is switched to OK. Click Erase errors. The green light is switched to OK.
► Click on TPS. The green light is switched OK. Otherwise, check the TPS sensor and ECU by Click on TPS. The green light is switched OK. Otherwise, check the TPS sensor and ECU by Click on TPS. The green light is switched OK. Otherwise, check the TPS sensor and ECU by
returning to the Function Test Menu
components, you must do the following:
enu.
Test / Active test you can test
45/54