Right-Hand Side Assembling; Clutch Assembling - SHERCO 125 Workshop Manual

ENGINE ASSEMBLING
Fit the stator and tighten its screw
•
7Nm torque.
• Fit the CHC screws
the wiring holding plate.
• Fit the flywheel, and using the locking tool Part
number 10985
80Nm torque.
• Fit the ignition cover then tighten its four screws
8
at a 8Nm torque.
❱❘ Right-hand side assembling
❱❘Clutch assembling
• Place the washer
40
5
5 6
and the screw
7
, tighten the CHC screw at a
1
and the kickstarter shaft.
at a
with
ST SERIES