ENGINE ASSEMBLING
❱❘ Gearbox assembling.
Prior to assembling, thoroughly oil all the parts
•
with the correct oil.
Assembling order of the forks is stamped on
•
each fork.:
-
The "Outside" mark matches the outside of
the shifting drum.
-
The arrow points to the front forward
direction.
•
First, start the assembly with the fork on the
selection star side..
•
Install it with the side stamped "outside" towards
the outside of the cylinder.
•
Put back in place the guide pin.
•
- Place the clip so that the right hand side passes
through the left hand hole to hold the guide pin
and then lock the clip through the right hand hole.
Always replace the pin retaining clips after
•
Make sure the pin retaining clip in well
positioned, as shown in the picture :
37
CAUTION
each removal
ST SERIES