Suspension Linkage Check - SHERCO 125 Workshop Manual

CHASSIS
• Check the needle bearings of both
sides.. In case of rust, replace them.
Otherwise, apply grease before
reassembling.
• Reassemble the set following the
reverse procedure and applying grease
on swingarm spindle and linkage shafts.

2.4 Suspension linkage check

• Loosen lower suspension shaft
2
.
shafts
• Loosen the tie-rod screw
• Remove all the shafts and the linkages.
Remove the linkage inner ring and check
the bushings
replace them by new ones.
Reassemble the set following the reverse
procedure , applying grease on the shafts and
bushings.
• Shock screw tightening torque : 40 Nm
• Linkage shaft tightening torque : 40 Nm
Tie-rod screw
14
1
and linkage
3
.
4
.
In case of wear sign,
tightening torque
: 40 Nm
ST SERIES
1
2
2
3
4 4