ENGINE ASSEMBLING
•
Fit the clutch basket and the clutch hub.
Using the tool Part number 10982, hold the
basket, fit the screw
torque.
Fit the first snap ring on the crankshaft, then the
r
spring washer
snap ring, and its big diameter facing the primary
drive gear. ( the cone points the inside of the
engine)
•
Fit the primary drive gear and its snap
ring
snap ring, compress the spring washer
by pushing the primary drive gear.
•
Taking care of their position, fit the clutch discs.
•
Fit the clutch pushrod and the clutch pusher
•
Fit the clutch spring pads so that their
chamfered side is facing upward.
42
e
and tighten it to a 60Nm
its little diameter towards the
t
. To make it easier to fit the
u
.
ST SERIES