SHERCO 125 Workshop Manual page 13

CHASSIS
• Remove the spring
with a cloth.
• Drain the oil.
• Put fork leg vertically and pour 250cc of
new oil inside.
•
Do a back and forth movement as shown in
the picture to prime the hydraulic system,
until you feel resistance.
•
Compress the fork tube and damping rod
to the maximum
•
Measure oil level from the top of the tube,
then fill until you reach the desired height.
Oil level : 140mm
• Reassemble, in this order : the spring, the
washer, the spacer, the conical spacer then the
cap.
•
Place the fork tube in a vise with a suitable
support so as not to damage it and tighten
a 12Nm torque.
the cap to
11
9
and clean it
.
ST SERIES
9