Brake Disc Change; Swingarm Bearings Check - SHERCO 125 Workshop Manual

CHASSIS

2.2 Brake disc change

•
As changing front brake disc, during assembling
apply medium threadlocker ( Loctite 243 ) on the
screws and tighten them to a 12Nm torque..
Reassemble the wheel following the
reverse procedure , applying a thin coat
of grease on the wheel spindle.

2.3 Swingarm bearings check

•
Undo the nut on the bottom part of the
swingarm and remove linkage shaft.
•
Unlock swingarm spindle
Linkage shaft tightening torque :
40 Nm
Swingarm spindle tightening torque :
50 Nm
•
Remove swingarm and take the two
2
intern spacers
13
1
and remove it.
out.
ST SERIES
1
1 2