Mitsubishi Electric MELDAS 60 Series Programming Manual page 60

OUT C ... Counter output
Bit device
X Y M L SM F
Device
Settin
g
value
Function
(1) If the operation results before the OUT command change from OFF to ON, the current value
(count value) will be incremented by one. When the value is counted up (current value >= setting
value), the contacts will change as shown below.
A contact
B contact Non-continuity
(2) The value will not be counted when the operation results are ON. (A pulse change is not required
to input the count.)
(3) If the operation results change from OFF to ON after the "current value >= setting value" is
established, the contact state will remain the same, however the current value will be
incremented by 1.
Execution condition
This is executed per scan regardless of the operation results before the OUT command.
Usable device
Word device
T C D R Z
Continuity
- 52 -
Con-
desig-
Pointer Level
stant
nation
K H P N
Setting value
(1 to 32767 is valid)
C0 K50
Device No.(C0 to 127)
Setting value
(1 to 32767 is valid for
C1 D10 the data register details)
Device No.(C0 to 127)
OUT C
Digit
No. of
steps Index
3