Audi Q7 2007 Repair Manual page 37

❑ Removing and installing. Refer to
⇒ "2.3 Intake Flap Control Vacuum Actuator, Removing and Installing", page 9
Intake Air Temperature Sensor - G42- / Manifold Absolute Pres‐
sure Sensor - G71- - Tightening Specification
– Tighten the bolts -arrows- to 10 Nm.
Lower Intake Manifold Section - Tightening Specification and Se‐
quence
– Tighten the bolts and nuts -arrows- in a diagonal sequence in
stages to 9 Nm.
Throttle Valve Control Module - J338- - Tightening Specification
– Tighten the bolts -arrows- to 10 Nm in a diagonal sequence.
Control Valve Control Unit - J808- - Tightening Specification and
Sequence
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
– Tighten the bolts in three steps as follows: permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Step Bolts
1. -5 and 6-
2. -6-
3. -5-
Tightening Specification
Install all the way in by hand.
10 Nm
10 Nm
Fuel Injection and Ignition - Edition 02.2015
Audi Q7 2007 ➤
.
33
3. Injection System