Audi Q7 2007 Repair Manual page 23

20 - Camshaft Position Sensor 2 - G163-
❑ Component location. Refer to
⇒ Fig. ""Camshaft Position Sensor and Exhaust Camshaft Control Valve Cylinder Bank 2 (left)"" ,
page 23 .
❑ Removing and installing. Refer to
⇒ "2.5 Camshaft Position Sensor G40 / Camshaft Position Sensor 2 G163 , Removing and Installing",
page 71 .
21 - Intake Manifold Runner Position Sensor 2 - G512-
❑ Component location. Refer to
⇒ Fig. "" Intake Manifold Runner Position Sensor -G336- Component Location"" , page 22
22 - Engine Coolant Temperature Sensor - G62-
❑ Component location. Refer to
⇒ Fig. "" Engine Coolant Temperature Sensor -G62- Component Location"" , page 24
Engine Control Module - J623- Component Location
♦ -1- inside the plenum chamber on the right side.
Accelerator Pedal Position Sensor - G79- / Accelerator Pedal Po‐
sition Sensor 2 - G185- Component Location
♦ In the accelerator pedal module -arrow-.
Note
The Accelerator Pedal Position Sensor - G79- and the Accelerator
Pedal Position Sensor 2 - G185- are part of the accelerator pedal
module and cannot be replaced separately.
Removing and installing. Refer to ⇒ Fuel Supply System; Rep.
Gr. 20 ; Accelerator Pedal Mechanism; Accelerator Pedal Module
with Throttle Position Sensors, Removing and Installing .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Fuel Injection and Ignition - Edition 02.2015
Audi Q7 2007 ➤
.
.
19
3. Injection System