Glossary Of Terms - Chore-Time C Installation Manual

Intermediate Control: .. . .. . . A
Item #2 Clamp: .. . . A two-piece,
riveted
used to secure
auger tubes to-
gether.
Adjustment Leveler: .. . .. . .. A cable locking de-
Throw-back: .. . .. . .. . .. . .. . .A cable/pulley arrangement
that allows cable to be routed to a desired location.
Double-back: . . .. . .. . .. . .. . .A cable/pulley arrangement
that reduces the load on the Power Winch.
Power Lift: . .. . .. . .. . .. . .. . .Red, cast iron winch used to raise and
Electro-Guard: . .. . .. . .. . .. . .A high voltage, low
Model C, C2, G, & H2 Operator's Manual

Glossary of Terms

feeder, equipped
with a switch, (located
near the center of the
feeder line) used to
control the feeding
system when partial
house brooding.
strap
vise used to conve-
niently adjust the
feeder to a level po-
sition.
lower the feeder line(s). Operated by a
hand crank or electric drill. Referred to
as Power Winch.
current shocking de-
vice used to keep
birds from setting on
the feeder line.
• Page 7
End Control: . .. . .. . .. . .. . .. A
Item #1 Anti-Roost Bracket: .. . . An
and bracket assembly mount-
ed on every fourth or fifth
clamp
wire.
Drop Line: .. . .. . .. . .. . .. . .. A section of cable
feeder, equipped
with a switch, (located
at the power unit),
used to control the
feeding system.
insulator
to support shocker
fastened to the
main cable, rout-
ed through a pul-
ley, down to the
feeder line.