Safety Information - Chore-Time C Installation Manual

Feeding systems

Table of Contents

Caution, Warning and Danger Decals have been placed on the equipment to warn of potentially dangerous situations. Care

should be taken to keep this information intact and easy to read at all times. Replace missing or damaged safety signs.

Using the equipment for purposes other than specified in this manual may cause personal injury or damage to the equipment.

This is a safety–alert symbol. When you see this symbol on your equipment, be alert

to the potential for personal injury. Chore-Time equipment is designed to be installed

and operated as safely as possible...however, hazards do exist.

Signal words are used in conjunction with the safety–alert symbol to identify

the severity of the warning.

DANGER .............identifies immediate hazards which WILL result

WARNING...........identifies hazards or unsafe practices which

CAUTION ............identifies hazards or unsafe practices which

DANGER—MOVING AUGER

This decal is placed on the Clean-Out Cover of the

FLEX-AUGER Control Unit.

Severe personal injury will result, if the electrical

power is not disconnected, prior to servicing the

equipment.

DANGER—ELECTRICAL HAZARD

Disconnect electrical power before inspecting or servicing equipment unless

maintenance instructions specifically state otherwise.

Ground all electrical equipment for safety.

All electrical wiring must be done by a qualified electrician in accordance with

local and national electric codes.

Ground all non-current carrying metal parts to guard against electrical shock.

With the exception of motor overload protection, electrical disconnects and

over current protection are not supplied with the equipment.

Model C, C2, G, & H2 Operator's Manual