Pod Encoder Notification - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

POD ENCODER Notification

The format of the POD ENCODER Notification from the OMNI-VII to the computer
via the serial port that the POD Encoder has been turned is as follows:
Format:
Where:
Example1:
Example2:
Note: Due to the architecture of the software within the OMNI-VII, it is highly likely
that you will only ever receive +1 or –1 encoder pulses.
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'!' <d0> <CR>
! = the ASCII '!' character (0x21)
<d0> = signed number of encoder turns.
!<0x01><CR> means that the encoder was turned right one pulse.
!<0xff><CR> means that the encoder was turned left one pulse.
OMNI-VII Programmer's Reference Guide 53 of 63