Table of Contents
Advertisement
Ethernet Settings – Query Only
In Remote Mode, the Ethernet settings can be queried. This includes the MAC
Address of the radio, the current state of RIPping, and the IP Address of the Computer
that the Radio is RIPping with. The RIP items are provided so that they can be checked
before trying to RIP, and if the radio is already RIPping, then the new program should not
attempt it. Otherwise, you will get very disjoint audio, going back and forth between the
two attempted RIP'er computers. This is permitted by the radio, so that if the IP address
of the source PC changes dynamically, then the Radio will keep up RIPping to the new
address as it comes in. This command also returns the compression level supported by the
radio (comp).
Format:
Where:
Example:
Returns:
Where:
Example1:
Example2:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'?' 'T' <CR>
'?' = the ASCII '?' symbol (0x3F)
T = the ASCII 'T' character (0x54)
?T<CR>
"T001945XXYYZZ" <n><ip3><ip2><ip1><ip0><comp><CR>
001945XXYYZZ = the MAC address of this OMNI-VII
<n> = 1 byte binary = 1 if the OMNI-VII is ripping; 0 if not
<ip3..ip0> = 4 byte binary IP address of the device that the
OMNI-VII is RIPping to.
<complevel> bit 0 = 1 supports 16 bit to 8 bit TRIP
bit 1 = 1 supports 16 bit to 8 bit RIP
T00194566CB14 <0x00> <0xC0> <0xA8> <0x01> <0 x0F>
<0x00> <CR>
Means the MAC Address = 00:19:45:66:CB:14
The OMNI-VII is NOT in use, It isn't RIPping.
The IP Address it was last RIPping to was: 192.168.1.15
Compression isn't supported.
T00194566CB14 <0x01> <0xC0> <0xA8> <0x01> <0 x7D>
<0x03> <CR>
Means the MAC Address = 00:19:45:66:CB:14
The OMNI-VII IS in use, It isn't RIPping.
The IP Address it is RIPping to is: 192.168.1.125
RIP and TRIP compression are supported.
OMNI-VII Programmer's Reference Guide
26 of 63
Advertisement
Table of Contents
