Where - At; Execution Control - Ten-Tec OMNI-VII 588 Programmer's Reference Manual

Where – AT
This command simply performs a notify.
Format:
Where:
Example:
Returns:
Returns:
Note: The Boot Loader returns: " DSP START" <CR>

Execution Control

The OMNI-VII has different execution events that are used in programming the
radio or in restoring original defaults.
Format:
Where:
Example:
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
XX <CR>
X = the ASCII 'X' character (0x58)
XX<CR>
" RADIO START – RADIO " <CR>
or
" RADIO START – REMOTE" <CR>
Z<X> <CR>
Z = the ASCII 'Z' character (0x5A)
<X> = ASCII 'Z' – Forces the OMNI-VII into flash update mode
<X> = ASCII "M" – Forces the OMNI-VII to do a Master Reset
ZM<CR> Would force a master reset
OMNI-VII Programmer's Reference Guide 21 of 63