RADIO SPEAKER ON/OFF
The Speaker on the Radio can be muted remotely. This also affects the external
speaker connected to the SPKR jack on the back of the radio.
Format:
Where:
Example1:
Example2:
NOTE: The headphone audio is still present, and is unaffected by this command.
TRIP Gain
The shift level of the TRIP Gain can be adjusted remotely.
Format:
Where:
Example:
Note: The default value for this item is 6. This was the value used in OMNI-VII
1.025 firmware before this feature was added in 1.026. If an invalid value is sent to
the OMNI-VII, it will default it back to 6. So it is good practice that when you set
the TRIP level, read it back and verify it is at the value that you had intended.
Rev 1.009
OMNI-VII Firmware Updates at www.rfsquared.com
'*' 'C2O' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C2O = the ASCII 'C2O' characters (<0x43><0x32><0x4F>)
<d0> = ASCII "0" = Unmuted (speaker audio audible)
= ASCII "1" = Muted (speaker audio muted)
*C2O0<CR> unmutes the internal/external speaker
*C2O1<CR> mutes the internal/external speaker
'*' 'C2P' <d0> <CR>
'*' = the ASCII '*' symbol (0x2a)
C2P = the ASCII 'C2P' characters (<0x43><0x32><0x50>)
<d0> = ASCII "1" .. "9"
*C2P1<CR> sets shift level of the TRIP Gain to 1
OMNI-VII Programmer's Reference Guide
50 of 63